SilverStone ST1500 Handbuch

ST1500STRIDER1500W continuous and 1600W peak power100% modular cables with cable bagEfficiency 85%~88% at 20%~100% loading with 80 PLUS Silver certifi

M/B 24PIN connectorSignal Pin Pin SignalEPS 12V 8PIN connector #1 & #2ATX 12V 4PIN (4+4PIN EPS 12V in split mode)Signal Pin Pin Signal9-2. Connect

ŔŕœŊŅņœġŔŕIJĶıı4PIN peripheral connector (HDD) 4PIN floppy connector (FDD)Signal Pin PinSignal8PIN PCI Express connector #1 & #2 &a

1. AC INPUT Iin18----9.0ArmsTable 1 AC Input Line Requirements Power factor correction (PF)>0.95 at full load.1-1. AC input requirementsThe input v

ŔŕœŊŅņœġŔŕIJĶıı2-1. DC voltage regulationParameter2-2. Load rangesParameter Min Nom. Max Peak UnitLoad Range+3.3V+5V+12V1,2,3,4,5,6,7,8-12V+5VSB+3.20+4

2-3. Output Ripple2-3-1. Ripple regulationParameter Ripple&Noise Unit2-3-2. Definition1.Maximum continuous total DC output power should not excee

2-3-3. Ripple voltage test circuitV outV returnAC GroundPower SupplyAC HotAC NeutralScope10uF0.1uFLoadThe ripple voltage of the outputs shall be measu

3. PROTECTIONThe power supply shall have current limit to prevent the +3.3 V, +5 V, and +12 V outputs from exceeding the values shown in Table 28. If

ŔŕœŊŅņœġŔŕIJĶıı4. TIMING4-1. Signal timing drawingFigure 2. is a reference for signal timing for main power connector signals and Figure 2. PW-OK Timin

5.3 Altitude6. SAFETY6-1. Underwriters Laboratory (UL) recognition. The power supply designed to meet UL6-2. The power supply must bear the German Bau

ŔŕœŊŅņœġŔŕIJĶıı9-1. Physical dimension8. MTBF8-1. MTBF (mean time between failures) calculation150 mm (W) × 86 mm (H) × 220 mm (D)The demonstrated MTBF