460W + 460W PS/2 redundant power supplyHot swappableIndustry Ieading reliabilityDurable zinc-plated surfaceConvenient pull-out handle barsST46GF
4.1 Over Current Protection This power supply shall have current limit to prevent the +5V, +3.3V, and +12V outputs from exceeding the values shown in
ST46GF5. Environmental Requirements 5.1 Temperature 5.2 Humidity 5.3 Altitude 5.4 Mechanical Shock The power supply (non-operating) shall not be damag
6. Agency Requirements 6.1 Safety Certification. 6.2 Input Leakage CurrentInput leakage current from line to ground will be less than 3.5mA rms. Measu
ST46GF7. Redundant Power Supply Function: 7.1 Redundancy The redundant power supply is 1+1=1 (460W+460W=460W) function power , each one module is redu
8. Reliability8.1 Mean Time Between failures (MTBF) The MTBF of the power supply shall be calculated utilizing the Part-Stress Analysis method of Bell
ST46GFP2: 8-Pin Processor Power Connector Connector housing: 8- Pin Molex : 39-01-2080 or Equivalent Contact: Molex 44476-1111 or Equivalent 4-Pin HD
SPECIFICATION SilverStone Gemini ST46GF (EFRP-2462-00) N+1 Hot-SwappableRedundant Power SupplyPS/2 460W+460W 1. General This specification describes t
ST46GF2.3 Input Power Factor Correction (Active PFC) The power factor at full load shall be ] 0.95 at nominal input voltage. 2.4 Input Current Har
2.9 Electrical Discharge, IEC61000-4-2 In addition to IEC61000-4-2, the following ESD tests should be conducted. Each surface area of the unit under
ST46GF043.2 DC Voltage Regulation, Ripple and Noise The power supply output voltages must stay within the following voltage limits when operating at
3.4 Capacitive Loading The power supply shall be stable and meet all requirements, except dynamic loading requirements, with the following capacitive
ST46GFItem rinUnits MIN MAXmSmSmSmSmSmSmSmSmSTsb_on-delay Tsb_on-delay Tvout_holdupTpwok_holdupTpson_on_delay Tpson_pwok Tpwok_onTpwok_offTpwok_lowTsv
Figure 2: Turn On/Off Timing3.6 Power Good Signal: PWOK PSOK is a power OK signal and will be pulled HIGH by the power supply to indicate that all the
ST46GF3.7 Remote On/Off Control: PSON# The PSON# signal is required to remotely turn on/off the power supply. PSON# is an active low signal that turns
Kommentare zu diesen Handbüchern