SilverStone NT01-PRO Handbuch Seite 1

HELIGONNITROGONSERIESManual

9NITROGON/HELIGON SERIESAMD1.Please check the holes of motherboard before installation then insert the square spacer into the centric hole of back-boa

10NITROGON/HELIGON SERIESAMD2.Install the back-board set to the motherboard and slip the pillars. (Remove the original AMD back-board)Закрепите монтаж

11NITROGON/HELIGON SERIESAMD3.Combine the AMD and INTEL clips with M3*6 screws then insert the clip set onto the back-board and tighten the nuts.Совме

12NITROGON/HELIGON SERIESAMD4.Please clean the surface of CPU before applying the thermal grease, then apply the Thermal grease evenly on CPU. На очищ

13NITROGON/HELIGON SERIESAMD5.Take off the film of CPU surface and placeheat-sink on CPU.Снимите защитную пластинку с нижней части радиатора и установ

14NITROGON/HELIGON SERIESAMD6.Install the crossbar through heat-sink and tighten the screws on the both of clips.Проведите планки через основу радиато

15NITROGON/HELIGON SERIESFAN Mounting1.Insert the fan clips into the holes of fan and hook the fan set into the groove on the heat-sink.Вставьте крепл

16NITROGON/HELIGON SERIESTwin tower heatsink with unbelievable cooling powerFAN Mounting2.Connect the fan connector with the motherboard. Installation

17Warranty InformationThis product has a limited 1 year warranty in North America, Europe, and Australia. For information on warranty periods in othe

18Additional info & contactsFor North America ([email protected])SilverStone Technology in North America may repair or replace defecti

1NITROGON/HELIGON SERIESComponents ListINTELAMDFAN MountingThe following manual and guides were carefully prepared by the SilverStone engineering team

lssue date: June, 2012NO. G11216070

2NITROGON/HELIGON SERIESComponents ListFan clip Back plate Square spacer Crossbar INTEL clipAMD clip Nuts Stand-off M3.5*30 screws M3*6mm screwsInsula

3NITROGON/HELIGON SERIESINTEL1.Please check the holes of motherboard before installation and insert the screws M3.5*30 into the correct holes of back-

4NITROGON/HELIGON SERIESINTEL2.Install the back-board set onto the motherboard and slip on the standoff.Закрепите монтажную пластину к материнской пла

5NITROGON/HELIGON SERIESINTEL3.Mount LGA2011 and INTEL clips and tighten the nuts.Установите интеловские зажимы и закрепите винты.Setzen Sie die LGA20

6NITROGON/HELIGON SERIESINTEL4.Please clean the surface of CPU before applying the thermal grease and then apply the Thermal grease evenly on CPU.На о

7NITROGON/HELIGON SERIESINTEL5.Take off the film of CPU surface and place heat-sink on CPU.Снимите защитную пластинку с нижней части радиатора и устан

8NITROGON/HELIGON SERIESINTEL6.Install the crossbar through heat-sink and tighten the screws on the both of clips.Проведите планки через основу радиат