Silverstone RS431U Bedienungsanleitung

RS431UStep2. Set RAID Mode 9 1.Set the RAID mode on the back of RS431U to RAID mode you require.2.Press the SET button and switch on the power at

RS431URAID Degrade / HDD Fault Alarm When the HDD is damaged, the access LED will be off and a beeping sound will occur. Press the SET button on the

RS431U11HDD Fault at RAID 0 and Combine ModeOn RAID 0 and combine mode if one HDD is damaged, all data will be lost. Please replace the damaged HDD an

RS431URAID Modes / RAID 0 - Striping The drives are shown as one large single volume but the total size will depend on the drive with the smallest ca

RS431U13RAID Modes / RAID 1 – Disk MirroringTwo drives show up as one volume but only 50% of the total capacity, depending on the drive with the small

RS431URAID Modes / RAID 10 - Stripe Of Mirrors RAID 10 is a high level data storage option where at least 4 hard drives are required. The total capac

RS431U15RAID Modes / Combine (BIG)Combine mode will add all existing hard drive into a single hard drive with large capacity.Der Kombinieren-Modus füg

RS431URAID Modes / RAID 3 and RAID 5 The parity information on RAID 3 is stored on a single drive, where RAID 5 stores the information across the ent

RS431U17SYSTEMSupport Windows XP/VISTA/7. Windows XP does not recognize hard drive in excess of 2TB. Under Windows 7/VISTA hard drives in excess of 2T

RS431U 18 ©2013 SilverStone Technology Co., Ltd. All Rights Reserved.All specifications are subject to change without prior notice. Warranty Info

RS431U3Hard drive installation1 Open the front door Откройте переднюю дверцуフロントドアを開く프론트 도어를 열고打開前門打开前门Ouvrez la porte d’accès frontalAbra la puerta

RS431U 4Hard drive installationCaution3 Close the front door близко переднюю дверцуフロントドアを閉める프론트 도어를 닫습니다關閉前門关闭前门Fermer la porte d’accès frontalCe

RS431URemove the HDD Open the door and release the latch. The HDD will pop out slightly then pull the HDD out gently with your hands.Откройте крышку

RS431UConnect to PC Connect all cables before turning on the power.*If your computer’s eSATA port does not support SATA Port multiplier please utiliz

RS431USleep Mode If hard drive is not accessed for 5 minutes or it is disconnected from computer (including shutdown) the sleep mode will automatical

RS431UCAUTION!! Changing the RAID mode requires formatting the drives. Make sure to backup all existing data first!Eine Änderung des RAID-Modus erfor