SilverStone ST1500 Handbuch PDF herunterladen (Seite 2)

1. AC INPUT

Iin

18----9.0

Arms

Table 1 AC Input Line Requirements

Power factor correction (PF)>0.95 at full load.

1-1. AC input requirements

The input voltage, current, and frequency requirements for continuous operation are stated

below.

The power supply must meet inrush requirements for any rated AC voltage, during turn on

at any phase of AC voltage, during a single cycle AC dropout condition, during repetitive

ON/OFF cycling of AC,and over the specified temperature range (Top). The peak inrush

current shall be less than the ratings of its critical components (including input fuse, bulk

rectifiers, and surge limiting device)

2. DC OUTPUT

SilverStone STRIDER ST1500

ATX12V / EPS 12V Switching Power Supply

With Active PFC

PS/2 1500W

This specification describes the requirements of 1500Watts switching power supply with an

stretch form-factor and EPS12V, +5V standby voltage, remote on/off control, full range line

input capability and forced air cooling characteristics.

1 2 3 4 5 6 7 ... 11 12

Keine Kommentare

SilverStone ST1500 Handbuch Seite 2