SilverStone ST40F-ESB Handbuch

ST40F-ESBST50F-ESBSTRIDER ESSENTIAL SERIESHigh efficiency with 80 PLUS Bronze certification24/7 continuous power output with 40 C operating temperatur

07A TTL compatible signal for the purpose of initiating an orderly start-up procedure under normal input operating conditions. During power up, this s

08The MTBF of the power should be 50,000 hours min.10. MTBF The product shall meet requirement for EN61000-3-2 & EN61000-3-3 :2003 standard of cla

G11222300

The following manual and guides were carefully prepared by the SilverStone engineering team to help you maximize the potential of your SilverStone pro

SPECIFICATIONSilverStone Strider EssentialST50F-ESBST40F-ESBATX12V 2.3 Switching Power SupplyWith Active PFC80 Plus BronzePS/2011.1 Scope2.1 Input Vol

022.3 Max. Input AC CurrentThe power supply must meet inrush requirements for any rated AC voltage, during turn on at any phase of AC voltage, during

03SST-ST40F-ESBNOTE:Noise test should be measured with 20 MHz bandwidth frequency oscilloscope. The output terminal shall add a tantalum capacitor of

043.5 Hold-up TimeDC +5V output maintains at least 16mS ,after power off , under 230V/50Hz 75%Load condition.3.6 5VSB5VSB is requierd for the impleme

054.1 Input ProtectionIn primary circuit of the power supply , a protected fuse is inserted. Only internal fault of the power supply will cause the fu

066.1 Temperature and Humidity6.2 Altitude6.1.1 OperatingTemperature 0 to 40 C Relative Humidity 20 to 90 %6.1.2 StorageTemperature -40 to 70 CRel